TigerTigerM Posted May 3, 2020 Share Posted May 3, 2020 Per Nicks instructions - "If you had everything inside the P3D folder, then Global Base must be uninstalled and installed again. You must run Verify files for all open LC products. You must run verify files for the Orbx Libraries. For good measure, also run Sync Simulator." -- I can't find where to do Sync Simulator. Thanks TTM Link to comment Share on other sites More sharing options...
Smudger Posted May 3, 2020 Share Posted May 3, 2020 Hello TTM, Orbx Central - Settings - Help - Sync Simulator Link to comment Share on other sites More sharing options...
pmb Posted May 3, 2020 Share Posted May 3, 2020 Hi, I think that's the forth person asking where the Sync function is within a couple of days. Which might hint to to a subpar place. Kind regards, Michael Link to comment Share on other sites More sharing options...
Nick Cooper Posted May 3, 2020 Share Posted May 3, 2020 Thanks for pointing this out yet again. I have added the path to the topic under the line referring to it. It was already there in the section by Ben. The Help section is exactly the correct place for this function which is not needed unless there is something wrong, or as in this case, something out of the ordinary is being done, replacing an entire simulator. Link to comment Share on other sites More sharing options...
TigerTigerM Posted May 3, 2020 Author Share Posted May 3, 2020 Thank you Gentlemen For your Help. TTM Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.