Badl4ndz Posted February 28 Share Posted February 28 Just fired up Orbx Central and it updated to v4.2.10. Afterwards, I noticed that Prepar3D v6 is no longer listed. A pretty obvious assumption can be made from that. Would I be correct in my assumption? Link to comment Share on other sites More sharing options...
Nick Cooper Posted February 28 Share Posted February 28 Hello, It has been switched off to allow testing. I am sure that was not your assumption but that is what is taking place. 3 Link to comment Share on other sites More sharing options...
Badl4ndz Posted February 28 Author Share Posted February 28 25 minutes ago, Nick Cooper said: Hello, It has been switched off to allow testing. I am sure that was not your assumption but that is what is taking place. Thanks for your speedy reply Nick. If only "The Management" processed the ability to communicate as well as you. We wouldn't all be left having to make assumptions 😉 4 2 Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted February 29 Share Posted February 29 I tend to always look at the changelog every time I see an update. 4 1 2 Link to comment Share on other sites More sharing options...
John Heaton Posted February 29 Share Posted February 29 welcome home Doug - good to see you are still with us - and missed by a few of us👍 2 Link to comment Share on other sites More sharing options...
Badl4ndz Posted February 29 Author Share Posted February 29 16 hours ago, Doug Sawatzky said: I tend to always look at the changelog every time I see an update. Thanks Doug, I've never looked for it or noticed it until you enlightened me. 1 Link to comment Share on other sites More sharing options...
Recommended Posts