Jump to content

Migrating...


arnobg

Recommended Posts

To Prepar3d that is...and I have to say I am finally getting it smooth with a few tweaks. Is everything looking as it should to you all?


 


2015-3-8_14-1-19-373_zps87vzxfru.png


 


2015-3-8_14-0-57-485_zpsesaox7ty.png


 


 


 


Is the way the lights abruptly end normal, as well as the blurriness at the edge of the day shot?


 


2015-3-8_14-4-18-663_zpsmkutpjhz.png


 


2015-3-8_14-5-26-789_zps9rvrtgps.png


 


 


Link to comment
Share on other sites

Shots look good but have a butchers at this post.

 

It made massive improvements to my P3D set up.

 

http://www.orbxsystems.com/forum/topic/88427-p3d-the-ultimate-settings/

 

Thanks for the tip I have seen the post, but I'm afraid to load up my cfg with tweaks, there are a LOT of tweaks in that post cfg.

 

What specifically gave you the best changes?

Link to comment
Share on other sites

Thanks for the tip I have seen the post, but I'm afraid to load up my cfg with tweaks, there are a LOT of tweaks in that post cfg.

 

What specifically gave you the best changes?

Firstly I made a back up copy of my cfg so that if things went wrong I still had the original.

 

Then I just made the suggested changes. I don't know anything about how the programme works but as others had successfully tried the adjustments I decided to give it a go.

The results are pretty obvious in these before and after shots.

 

ep1.jpg

LJC2.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...