davenicoll Posted September 18, 2014 Share Posted September 18, 2014 Hi, Just purchased and downloaded KMRY. Tested it out and found the whole airport was elevated...Like it had a 12ft perimeter ridge.. I have FS Global 2010 FTX installed as my mesh. How can I get it so it blends flat with the rest of NCA? Dave Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted September 18, 2014 Share Posted September 18, 2014 not at home atm, but check scenery/world/scenery folder for KMRY elevation adjustment file, change the extension to.off or.bgl and see if that resolves the issue, make sure that there is only one KMRY elevation adjustment file active Link to comment Share on other sites More sharing options...
ESzczesniak Posted September 19, 2014 Share Posted September 19, 2014 Is this not perhaps realistic? The ILS 10R approach chart: http://155.178.201.160/d-tpp/1410/00271IL10R.PDF "ILS unusable from I-MRY 1.8 NM inbound". Link to comment Share on other sites More sharing options...
Jarrad Marshall Posted September 19, 2014 Share Posted September 19, 2014 G'day Dave, If Wolter's suggestion doesn't yield the result you're looking for, could you post up a screenshot for us? There could be a couple of different causes for this, and the screenshot will help point in the right direction. Cheers, Jarrad Link to comment Share on other sites More sharing options...
Mallard Posted September 19, 2014 Share Posted September 19, 2014 Hi Dave, the airport IS elevated. Check out this pic from the Orbx product page - they didn't put the lighting on these constructions for nothing Cheers Mallard Link to comment Share on other sites More sharing options...
Voyager Posted September 19, 2014 Share Posted September 19, 2014 Is this not perhaps realistic? The ILS 10R approach chart: http://155.178.201.160/d-tpp/1410/00271IL10R.PDF "ILS unusable from I-MRY 1.8 NM inbound". No! This means you will not have full ILS after DH: only Localizer. See the chart of descent to the opposite runway (28L) only has the Localizer: no GS (Glide Slope). Link to comment Share on other sites More sharing options...
ESzczesniak Posted September 19, 2014 Share Posted September 19, 2014 No! This means you will not have full ILS after DH: only Localizer. See the chart of descent to the opposite runway (28L) only has the Localizer: no GS (Glide Slope). I'm sorry, but can you explain tihs more. I understand that it means there is not a full ILS following this, but there is usually a reason...such as the vertical guidance is no longer valid after this point. Link to comment Share on other sites More sharing options...
Voyager Posted September 19, 2014 Share Posted September 19, 2014 I'm sorry, but can you explain tihs more. I understand that it means there is not a full ILS following this, but there is usually a reason...such as the vertical guidance is no longer valid after this point. That`s it! Cheers, Link to comment Share on other sites More sharing options...
davenicoll Posted September 25, 2014 Author Share Posted September 25, 2014 No joy at the moment... How can I post a screenshot? Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted September 25, 2014 Share Posted September 25, 2014 No joy at the moment... How can I post a screenshot? have a go at this here => http://www.orbxsystems.com/forum/topic/38447-how-to-post-a-screenshot-on-the-orbx-forums/?p=335815 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.