StefanBravo Posted October 11, 2020 Share Posted October 11, 2020 Hi all, I'm having a problem with my EU England scenery near Manchester, where the correct textures are not being loaded. I already performed a file check for Orbx Global and EU England in Orbx Central, which did not resolve the problem. Regards, Stefan Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted October 11, 2020 Share Posted October 11, 2020 Hi Stefan, welcome to the forums Please see the below pinned topic. Link to comment Share on other sites More sharing options...
StefanBravo Posted October 11, 2020 Author Share Posted October 11, 2020 Hi Doug, Thanks for your fast reply! I followed the instructions in the topic, but the problem persists. Stefan Link to comment Share on other sites More sharing options...
Nick Cooper Posted October 11, 2020 Share Posted October 11, 2020 Hello, unless you have installed someone else's landclass definitions, this fix does work. Please start again but make sure that you perform each step in the exact order that it is written. Link to comment Share on other sites More sharing options...
StefanBravo Posted October 11, 2020 Author Share Posted October 11, 2020 Hi Nick, I did the exact procedure again: validated my Orbx Library, Global Base, OpenLC EU and EU England files, renamed my terrain.cfg, ran P3D and therafter the Orbx synchronizer. This is what the sim looks like now: EU England and OpenLC Europa activated EU England deactived, openLC Europe still activated I don't use any other landclass than Orbx's. Stefan Link to comment Share on other sites More sharing options...
Nick Cooper Posted October 12, 2020 Share Posted October 12, 2020 Thanks, I see no mention of the lclookup.bgl file, which is the most likely cause of this problem? Link to comment Share on other sites More sharing options...
StefanBravo Posted October 12, 2020 Author Share Posted October 12, 2020 Hi Nick, All my Orbx products are installed into an Orbx central library, not in the P3D main folder. Can you confirm I should still try to rename that bgl, while the other forum topic mentions that should not be done in this case? Thanks! Link to comment Share on other sites More sharing options...
Nick Cooper Posted October 12, 2020 Share Posted October 12, 2020 Hello, you should not have to, as that file should only be affected by Orbx Central. Of course, you must have the Orbx Libraries installed and also active. Link to comment Share on other sites More sharing options...
StefanBravo Posted October 12, 2020 Author Share Posted October 12, 2020 2 hours ago, Nick Cooper said: Of course, you must have the Orbx Libraries installed and also active. They are installed and active. Any suggestion as to what I should/could do now? Link to comment Share on other sites More sharing options...
StefanBravo Posted October 13, 2020 Author Share Posted October 13, 2020 When going through Orbx Central, I found out that the insertion point for OpenLC was not set to 'below Orbx airports and regions'. Changing that fixed the problem :). Stefan Link to comment Share on other sites More sharing options...
Nick Cooper Posted October 13, 2020 Share Posted October 13, 2020 Good news, thanks. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.