Richard67 Posted February 5, 2018 Share Posted February 5, 2018 JUST INSTALLLED FTX GOBAL, FTX GOBAL OPENLC NA AND GOBAL TREES-- LIKE THE RESULTS.... LOADING GOBAL VECTOR CAUSES AIRPLANES TO DISAPEAR SO UNINSTALLED FOR NOW (DID RUN ELEVATION CORRECTION AND THAT APPEARED TO WORK) HOWEVER I HAVE SEVERAL ADD ON AIRPORTS. STARTED WITH FLIGHTBEAM KDEN. AIRPORT LOADED WITH NO BUILDINGS. HOW DO I CORRECT? LOOKED ON THIS SITE BUT COULD NOT FIND SOLUTION. THANK YOU. RICHARD Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted February 5, 2018 Share Posted February 5, 2018 Hi Richard Could we please get some more info from you, starting with a product order/transaction ID? Thanks Doug Link to comment Share on other sites More sharing options...
Stewart Hobson Posted February 5, 2018 Share Posted February 5, 2018 The OP must actually purchase Flightbeam's KDEN so that it installs completely, not merely test it out on a trial basis. If in doubt, it is explained on their website, I believe. Link to comment Share on other sites More sharing options...
Nick Cooper Posted February 5, 2018 Share Posted February 5, 2018 Thanks Stewart, very helpful. Hello Richard, welcome to the forums. Please don't write in all capital letters. Thanks. Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted April 3, 2018 Share Posted April 3, 2018 Hi Richard, in response to the PM I received from you... Please apply the below procedure. Ensure all of your 3rd party addons are at the top of your scenery library and above your FTX entries. Then in FTX Central 3 Insertion points, move "FTX entries should be inserted below" just below your last 3rd party addon. Then move the "openLC entries should be inserted below" just below your FTX entries. and click "Save". Then, if you have Vector installed, there is a Vector control panel access button at the bottom of the FTXC3 settings page. When you open it you can select the amount of road coverage etc, be sure to uncheck the "Frozen Surface (in winter only)"option, and check the Australia Add-Ons under the “Settings” tab, then go to the Airport Elevation Correction (AEC tool) tab and run the auto configuration process and be sure to click on "Appy" when it is done scanning. And if you are using P3Dv4: Please check from in game top of screen under Options/Add-ons that ObjectFlow2 is checked enabled. Please check that “Use ObjectFlow 2 in Prepar3D v4” in FTXC3 settings is checked enabled. Cheers Doug Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.