glasklar Posted February 1, 2017 Share Posted February 1, 2017 Something is not correct with Australia. The textures changes from ground to water and then again from water to ground, there are ships on the ground instead of water and so on, especially near Sidney. The box in the Vector Configuration, that I have Austalia installed is ticked. The various features in the Vector Configuration are unticked. Any help would be very appreciated. Regards, Heinz Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted February 2, 2017 Share Posted February 2, 2017 Hi Heinz Is this happening anywhere else or just Australia? If it is happening else where, you may have a corrupt terrain.cfg file, then have a look at the below link. Link to comment Share on other sites More sharing options...
glasklar Posted February 2, 2017 Author Share Posted February 2, 2017 Hi Doug I have this problem only in Sidney and nowhere else in Australia or all over the world. Heinz Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted February 2, 2017 Share Posted February 2, 2017 Heinz Do you have any other addon scenery installed for the same area? Link to comment Share on other sites More sharing options...
glasklar Posted February 2, 2017 Author Share Posted February 2, 2017 Hi Doug Yes I have Sidney Airport (YSSY) from Fly Tampa installed. Regards, Heinz Link to comment Share on other sites More sharing options...
Jon Clarke Posted February 2, 2017 Share Posted February 2, 2017 First of all try and disable the Fly Tampa airport in your scenery library and see if the problem is gone. If it is, then go here and see if it helps you to enable the Fly Tampa addon:http://www.orbxsystems.com/forum/forum/80-ftx-compatibility-forum/ Link to comment Share on other sites More sharing options...
glasklar Posted February 2, 2017 Author Share Posted February 2, 2017 Hi Doug, hi jjaycee1 I disabled in the scenery library "Fly Tampa-Sydney_LC" and in the "Fly Tampa/Sydney/scenery" folder in FSX the "Sydney_Mesh.bgl". Everything is fine now. Thank you very much for your help. Regards, Heinz Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.