rogera Posted July 22, 2014 Share Posted July 22, 2014 I have followed Holger's instructions including using the backup terrain.cfg and then cycling several times through the FTX Central control panel. I am flying in North Yorkshire near Dishforth with Eu ticked. I have all of the UK and Eire installed as well as Eu lc and Global Vector. Link to comment Share on other sites More sharing options...
rogera Posted July 22, 2014 Author Share Posted July 22, 2014 As added help with this issue, I don't get morphing when on the same flight but in Global/Hybrid mode. Link to comment Share on other sites More sharing options...
Holger Sandmann Posted July 22, 2014 Share Posted July 22, 2014 Hi Roger, that sounds as if your openLC EU entries might be above the FTX airports and regions block in the scenery library; they should be underneath, meaning at lower display priority. Cheers, Holger Link to comment Share on other sites More sharing options...
GlennH Posted July 23, 2014 Share Posted July 23, 2014 http://www.orbxsystems.com/forum/topic/81831-setting-your-openlc-entries/ Link to comment Share on other sites More sharing options...
rogera Posted July 23, 2014 Author Share Posted July 23, 2014 Hi Holger, after purchase I moved all my eu lc files down to Edwards afb but on checking again they have all moved up to the rest of my ORBX regions and airports. I followed the guide but I had difficulty understanding the Insertion point setting in FTX Central. Perhaps with some clarification I could make them stay put? Link to comment Share on other sites More sharing options...
Vlad Maly Posted July 23, 2014 Share Posted July 23, 2014 Hi: As stated in another thread, it is by far the best to use the free Scenery Configurator to shuffle the files around. You can move the whole block of entries at the same time. http://www.orbxsystems.com/forum/topic/81837-how-to-quickly-move-the-olc-entries-in-the-fsx-scenery-library-screen/ Link to comment Share on other sites More sharing options...
rogera Posted July 23, 2014 Author Share Posted July 23, 2014 Thanks Vlad, that's very useful. I don't understand how to make them stay put with the FTX insertion tool though. Link to comment Share on other sites More sharing options...
Dieter Posted July 23, 2014 Share Posted July 23, 2014 This might be helpful: http://www.orbxsystems.com/forum/topic/81831-setting-your-openlc-entries/ Dieter Link to comment Share on other sites More sharing options...
rogera Posted July 23, 2014 Author Share Posted July 23, 2014 I believe I have now cured the problem using the scenery configurator and FTX Central insertion point tool. Thanks to all who replied. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.