MichaelMoe Posted March 9, 2014 Share Posted March 9, 2014 Hi, Again i have bought the Vector on day one i think but not installed it after i had some performance problems in KLAX with version 1.0 Now that 1.1 is out i was wondering if VECTOR will make any changes to FTX regions ? I dont want to mess that up ) Thanks Michael Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted March 9, 2014 Share Posted March 9, 2014 Hi Michael, Vector 1.1 has been completely reworked from the ground up, you can install it over the top and should work fine, it did at my end Link to comment Share on other sites More sharing options...
MichaelMoe Posted March 9, 2014 Author Share Posted March 9, 2014 Thanks. But does VECTOR add anything to my Regions which have accurate roads etc? I only want VECTOR on the rest of the world. Michael Link to comment Share on other sites More sharing options...
bunchy Posted March 9, 2014 Share Posted March 9, 2014 I have found Vector 1.1 to incorrectly adjust airport elevations with FTX England and Australia. It appears to treat all airfields in the FTX full regions as add ons, so disabling them one by one in the new configurator is your only option at the moment. But.... Disabling them with the configurator didn't work for me but does for some. Long story short, I went back to Vector 1.0, where no such elevation problems in my regions. I'll await 1.2 and evaluate what others find before I try it. Thanks Stu Link to comment Share on other sites More sharing options...
Holger Sandmann Posted March 9, 2014 Share Posted March 9, 2014 Hi Michael, FTXG Vector does not add anything to the regions, which is why you need to keep the Vector scenery library menu at lower display priority = below the FTX region and airports block of entries. Cheers, Holger Link to comment Share on other sites More sharing options...
leonperrins Posted March 9, 2014 Share Posted March 9, 2014 I regret to say that I have been obliged to un-install Vector. It was causing too many elevation problems when Group Flying. It looks like a bad buy at present. Link to comment Share on other sites More sharing options...
MichaelMoe Posted March 9, 2014 Author Share Posted March 9, 2014 Hmm Thanks i guess. I remember recalling from 1.0 that i should not touch the scenery entries as it could mess things up. I will make a system image and then try 1.1. Are there a simple on /off switch? Michael Link to comment Share on other sites More sharing options...
Rob Newman Posted March 9, 2014 Share Posted March 9, 2014 Hmm Thanks i guess. I remember recalling from 1.0 that i should not touch the scenery entries as it could mess things up. I will make a system image and then try 1.1. Are there a simple on /off switch? Michael If your install goes correctly, Vector will place itself below your FTX full regions automatically... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.