longrangecruise Posted August 7, 2019 Share Posted August 7, 2019 Quote Your Central log file provides us important information, please attach it to your support requests. You can find it at the following locations, or by pressing Control + Shift + L. Windows: %APPDATA%/Orbx/Central/central.log macOS: ~/Library/Application Support/Orbx/Central/central.log Linux: ~/.config/Orbx/Central/central.log You can delete this box/quote once your log is attached Operating system: W10 64 Simulator: P3D v4.5HF1 Screenshot: Issue: Hi, my P3Dv4 is almost unusable and stuck at 70 to 74%. for several minutes. It does load, but it takes around 12-15’ (even when only having a few scenes in AUS selected active). In v4 I migrated all of my many add-ons to a new library on my C drive, which is a SSD and also holds P3D. Please help me resolve this issue. Regards central.log Link to comment Share on other sites More sharing options...
longrangecruise Posted August 7, 2019 Author Share Posted August 7, 2019 I checked again it is actually the range between 70 and 83% that takes over 15’ to load. Link to comment Share on other sites More sharing options...
Nick Cooper Posted August 7, 2019 Share Posted August 7, 2019 Hello, how are you deactivating scenery? Link to comment Share on other sites More sharing options...
longrangecruise Posted August 7, 2019 Author Share Posted August 7, 2019 Hi Nick, I use Simstarter NG. Link to comment Share on other sites More sharing options...
Nick Cooper Posted August 7, 2019 Share Posted August 7, 2019 Thanks, I am not using either the Orbx Migration or SimStarter. Perhaps the developers can help out. @Mitchell Williamson @Josh Koz Link to comment Share on other sites More sharing options...
longrangecruise Posted August 7, 2019 Author Share Posted August 7, 2019 That would be nice. I am using the first column AFI+ASI with only a few add-ons sctive. The awkward sequence is also visible . Link to comment Share on other sites More sharing options...
longrangecruise Posted August 7, 2019 Author Share Posted August 7, 2019 Please note after the migration and the initial run of P 3-D there was no other tool involved. Only afterwards when I noticed double entries into scenery library I used simstarter and P4A0. Link to comment Share on other sites More sharing options...
longrangecruise Posted August 8, 2019 Author Share Posted August 8, 2019 Could you at least tell me how to start over or revert back to v3? Link to comment Share on other sites More sharing options...
longrangecruise Posted August 9, 2019 Author Share Posted August 9, 2019 It’s disappointing not to get any further support. I am now back with version three, where everything looks and runs beautifully There should be a guide how to uninstall and what to do when things go wrong. After several hours of troubleshooting and researching I found a solution for the loading issue: Delete or replace the scenery.cfg with a backup version. I hope this helps anybody with the same problem. You may close this topic now. Regards Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.