Spiros80 Posted May 9, 2019 Share Posted May 9, 2019 Hi to all i recently installed in the sim all three packages- base , vector and openLC. After every installation I was checking the result in the sim and I was very happily surprised up until I installed openLC. After that ,for some reason, the sim reverted to default scenery by itself. Between the installations I didn't install any other scenery or add on. When I uninstall openLC, I can clearly see base and vector coming to life again (the difference between them and the default is enormous). I'm running P3D 4.5 sim with REX ultimate airport HD, GSX level2, Ultimate Traffic Live and Active Sky 4. I cannot understand what is happening when I install openLC , is there an explanation or solution to this? Link to comment Share on other sites More sharing options...
Smudger Posted May 9, 2019 Share Posted May 9, 2019 Hello Spiros, welcome to the forums. Have you also installed the Orbx Libraries ? Link to comment Share on other sites More sharing options...
Spiros80 Posted May 9, 2019 Author Share Posted May 9, 2019 Hi and thanks for the welcome, yes i I have them installed. Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted May 9, 2019 Share Posted May 9, 2019 Hi First, Please apply the below basics. Ensure the Orbx Libs are installed and up to date. (is there a blue notification above the settings button in FTXC3?) Ensure all of your 3rd party non Orbx addons are at the top of your scenery library and above your FTX entries. Then in FTX Central 3 Insertion points, move "FTX entries should be inserted below" just below your last 3rd party addon. Then move the "openLC entries should be inserted below" just below your FTX entries. and click "Save". Then run the "Force Migration" option in FTXC3 settings. Then, if you have Vector installed, there is a Vector control panel access button at the bottom of the FTXC3 settings page. When you open it you can select the amount of road coverage etc, be sure to uncheck the "Frozen Surface (in winter only)"option, and check the Australia Add-Ons under the “Settings” tab, then go to the Airport Elevation Correction (AEC tool) tab and run the auto configuration process and be sure to click on "Appy" when it is done scanning. Link to comment Share on other sites More sharing options...
Spiros80 Posted May 10, 2019 Author Share Posted May 10, 2019 Hi, I went through all the steps that Doug mentioned and now everything seem to be working fine. I guess something was messed up at the library with all my addons. Thank you all for the help! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.