Ghost327 Posted April 12, 2017 Share Posted April 12, 2017 Hello everyone! I have been flying on p3d for the past 2 years but after i installed my ORBX LOWI scenery my ground scenery stops loading whenever i fly to LOWI or depart from LOWI. Everything get's really blurry in the air but on the ground everythings runs perfectly. I have an i7-6700k and an Asus strix GTX1060. I managed to run my P3D with 60FPS and it still is running so i don't think it depends on my system specs. So i think it is because i'm flying close to mountains or something. Here are some Pictures: https://drive.google.com/file/d/0BwX51VOqx_9QdnBnMU5Yc3h0aXc/view?usp=sharinghttps://drive.google.com/file/d/0BwX51VOqx_9QbUFCTXZOZTlqSE0/view?usp=sharing ADDONS: -ORBX Global, Trees, Open LC Europe -EZDOK camera -Tweaked with PTA -REX 4 (with soft clouds) -TOGA ENVTEX Link to comment Share on other sites More sharing options...
Richard Lincoln Posted April 14, 2017 Share Posted April 14, 2017 Hi, Typically this happens when your sliders are up too high, please check what occurs with a default aircraft in the same position, and also matching your sliders to the hardware you have on your PC. If you set your settings to what is recommended in the sim, then adjust them slightly until you are not receiving blurries. Link to comment Share on other sites More sharing options...
Jon Clarke Posted April 14, 2017 Share Posted April 14, 2017 I would also look at deleting your shaders file, checking your scenery library insertion point and make sure that LOWI is above OLC EU. I personally don't think it is your PC specs as I get extremely good visuals on max settings in LOWI with a lower spec PC, 4.6GB CPU and 780 GPU. You are also only doing about 140 knots in the first pic so it is not as though you're flying at speed and the sim/GPU can't keep up with loading the scenery. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.