Lakelandterrier Posted December 13, 2016 Share Posted December 13, 2016 Installed ENHF. Have deleted all ENHF files from other scenery and checked in file explorer. (AoN airport and ground). Ok to fly in and land. Trying to use it as take off airport results in a crash directly after loading. (Plane crash not the sim.) Link to comment Share on other sites More sharing options...
Finni Hansen Posted December 13, 2016 Share Posted December 13, 2016 HiIs your mesh resolution set to 5 meters?Do you have any AI addon packages?Does it happen with -all- aircraft?Finn Link to comment Share on other sites More sharing options...
Jon Clarke Posted December 13, 2016 Share Posted December 13, 2016 Check to see if you have Crash Detection set as ON. If so then disable it. It is in your Options in the sim. Then see if it still happens Link to comment Share on other sites More sharing options...
Lakelandterrier Posted December 13, 2016 Author Share Posted December 13, 2016 Hi Mesh is at 5 m. I have Airports of Norway, but have removed all ENHF files. I also tried to disable the add-ons entirely with no effect. Turning off crash damage makes it possible to proceed. Visually the aircraft is dropped onto the tarmac from a couple of metres when the scenario initiates hence the "crash". It does happen with all aircraft (I tried 4) Regards Ulf Link to comment Share on other sites More sharing options...
Lakelandterrier Posted December 13, 2016 Author Share Posted December 13, 2016 The aircraft is always placed at GA ramp small even if "active runway" is chosen Link to comment Share on other sites More sharing options...
mars03 Posted December 13, 2016 Share Posted December 13, 2016 There is an mistake in the orbx_cpl_ENHF.xml Link to comment Share on other sites More sharing options...
Finni Hansen Posted December 13, 2016 Share Posted December 13, 2016 The aircraft is always placed at GA ramp small even if "active runway" is chosen That is intentiona.The runway is only a small dummy because of the sloping terrain. There is an mistake in the orbx_cpl_ENHF.xml Care to elaborate? Link to comment Share on other sites More sharing options...
mars03 Posted December 13, 2016 Share Posted December 13, 2016 I am using FSX and P3D. In the orbx_cpl_ENHF.xml from FSX it looks: <onPath>ORBX\FTX_EU\FTX_AA_ENHF\Scenery\enhf_P3D_Objectflow.xml</onPath> <offPath>ORBX\FTX_EU\FTX_AA_ENHF\Scenery\enhf_P3D_Objectflow.xml.off</offPath> This can't be right!!! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.