wulfbindewald Posted November 20, 2015 Share Posted November 20, 2015 Hi There, unfortunately no control panel under "configure" in FTXC shown. The update to SP2 was ok and updated version has been applied as follows: FTX NA NCA Northern California V1.20 Patch 002 November 2015 orbx_cpl_FTXNANCA.xml from 09.11.2015 Wulf Link to comment Share on other sites More sharing options...
Ed Correia Posted November 20, 2015 Share Posted November 20, 2015 Re-start FTX Central and allow it to re-sync. Link to comment Share on other sites More sharing options...
Adam Banks Posted November 20, 2015 Share Posted November 20, 2015 Ed - I get the same problem too. This is in P3Dv3 mode. I have NCA, PNW, PFJ and AU installed. No Control panels for any of them (though I think only NCA has one). I restarted FTX Central a few times. However - I can get to the panel OK via the "Offline" tool. Great to have NCA in P3Dv3!!! Adam. Link to comment Share on other sites More sharing options...
wulfbindewald Posted November 20, 2015 Author Share Posted November 20, 2015 Thanks Ed, interesting though that a FTXC restart alone where a sync is automatically done, is not sufficient. Only the resync in FTXC - Troubleshouting - "Resync Orbx produxts" did it. Wulf Link to comment Share on other sites More sharing options...
Adam Banks Posted November 20, 2015 Share Posted November 20, 2015 EDIT_ I resynced using the "Troubleshooter. That brought it to life! Adam Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.