Mickel Posted July 30, 2015 Share Posted July 30, 2015 Hi Folks What have I done wrong? The following are some pics of CDG (perspective is messed up from being zoomed right out), with trees and buildings where they shouldn't be. FTX Central is set to Global, no hybrid. I check airports outside of OpenLC, and don't have this issue. I've run the Vector AEC. I've also had it at Liege and Budapest. I don't remember having it at smaller airfields. Other than a few airports by others, all installed scenery is Orbx (Vector, Global and openLC in the above pics), with Pilots mesh. Thanks Mike Link to comment Share on other sites More sharing options...
Nick Cooper Posted July 30, 2015 Share Posted July 30, 2015 The OpenLC block of entries needs to be just above Edwards AFB with the base area at the bottom. Please try a search of your FTX_VECTOR folder for LFPG and report what is found. Is LFPG one of your addons? Link to comment Share on other sites More sharing options...
Mickel Posted July 30, 2015 Author Share Posted July 30, 2015 Hi Nick Do I need to move them down a bit and reorder numerically?: In the FTX Vector folder I have: ABP_LFPG.inactive AEC_LFPG.inactive APT_LFPG.inactive All of my non-Orbx airports in Europe are default. That being said, I do use MyTraffic 5.4b for my AI and that does have a lot of its own BGL files for airports, including EBBR, LFPG & LHBP. Where I have an add on airport such as KIAD or KPHX I change those BGLs to BAKs to avoid potential clashes. I haven't done that throughout Europe. Another thing (which may be a red herring) is that my autogen takes a long time to load when loading a flight. Suggestions welcome. Thanks Mike Link to comment Share on other sites More sharing options...
Mickel Posted July 30, 2015 Author Share Posted July 30, 2015 Post script: I tidied up the scenery order and changed the MT CDG BGL to BAK. That didn't solve it: Mike Link to comment Share on other sites More sharing options...
Voyager Posted July 30, 2015 Share Posted July 30, 2015 Hi Mickel To avoid a lot of work set the "Insertion Point" for Orbx products, as the graph below. Drag the orange "FTX" as in the graph-shot: Cheers, Link to comment Share on other sites More sharing options...
Nick Cooper Posted July 30, 2015 Share Posted July 30, 2015 Hi Nick In the FTX Vector folder I have: ABP_LFPG.inactive AEC_LFPG.inactive APT_LFPG.inactive Suggestions welcome. Thanks Mike Hello Mike, Do I take it that there is no ABP_LFPG_Default.bgl file? If not, this is the cause of your problem and the solution is to download Vector again from your FSS account, delete the entire FTX_VECTOR folder and then re-install. Link to comment Share on other sites More sharing options...
Mickel Posted July 30, 2015 Author Share Posted July 30, 2015 Thanks Nick. I'll try that and report back. Voyager, that will save me a goodly amount of time next time I have to do a re-install. Thanks. Mike Link to comment Share on other sites More sharing options...
Mickel Posted July 31, 2015 Author Share Posted July 31, 2015 All sorted. There was no fourth airport file, so I downloaded and installed Vector again. Thanks for your assistance. One happy camper. Now I can finally enjoy OpenLC in all its glory. Cheers Mike Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.