Hanse_Rolf Posted February 6, 2015 Share Posted February 6, 2015 I am using FTX GLOBAL and VECTOR with FSX as well as with Prepar3D 2.4 and have the same problems in both simulators using the standard airport of KDEN (Denver). If I use the Airport Elevation Correction for KDEN and disable the correction (= ALT then 5.450 ft) everything is OK but there are a lot of trees around the runway and on the ramp. If the correction is enabled (then =ALT then 5.340 ft) there are no trees / bushes but the PAPI lights are in the air and the plane also tries to land in the air because the glideslope ends much higher e. g. at 5.450 ft. So my question is how to remove those trees/ bushes if the Airport Elevation Correction for KDEN is disabled. Regards, Rolf Link to comment Share on other sites More sharing options...
coolgovind180 Posted February 6, 2015 Share Posted February 6, 2015 this should have been posted in the ftx global vector forum...and please see the below topic: and read carefully: http://www.orbxsystems.com/forum/topic/91472-aec-tool-and-default-fsx-airport-issues/ Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.