RocheTJ Posted December 14, 2014 Share Posted December 14, 2014 I understand that FTX regions and airports should be above Vector, LC and Mesh. Could anyone tell me where Vector, LC and Mesh should be located in relation to 1107 Base, 1106 Base, 1105 Base, etc. and the default Edwards_AFB, Berlin, Longleat, Istanbul, Reno, etc, FSX layers? Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted December 14, 2014 Share Posted December 14, 2014 have a read here Tom => How to configure openLC scenery library entries (1).pdf Link to comment Share on other sites More sharing options...
RocheTJ Posted December 14, 2014 Author Share Posted December 14, 2014 Thanks Wolter... that clarifies the correct location for LC layers..... how about Vector layers (and FS Global Ultimate Mesh layers)? Are they immediately below the LC layers or above them? Link to comment Share on other sites More sharing options...
Stewart Hobson Posted December 14, 2014 Share Posted December 14, 2014 Hello, Tom. The FS Global Ultimate can go directly below the LC entries, and the Vector_OBJ, Vector_APT, Vector_CVX, and Vector_EXX directly below FS Global and above the Base xxxx entries. The Vector_AEC goes way down the list, directly above the Default scenery entry, which makes the third from the bottom of the Scenery library. Hope this helps. Stew Link to comment Share on other sites More sharing options...
RocheTJ Posted December 15, 2014 Author Share Posted December 15, 2014 Stew --- got it..... thanks much! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.