FentiFlier1 Posted June 4, 2014 Share Posted June 4, 2014 Hello to everyone on the forum . I purchased FTX Northern California a few weeks ago and it was working fine until I installed some new sceneries. Since then autogen buildings aren't showing up - but the trees are. I'm not too sure what to do about it and would be grateful for some advice. Should I delete then reinstall NCA? The sceneries I installed after NCA were: Death Valley freeware from OZx France VFR Nord Pas de Calais VFR. Thanks, Owen. Link to comment Share on other sites More sharing options...
jlsaghaa Posted June 4, 2014 Share Posted June 4, 2014 France VFR autogen is not compatible with ORBX one .... regards JL Link to comment Share on other sites More sharing options...
FentiFlier1 Posted June 4, 2014 Author Share Posted June 4, 2014 Thanks JL, I thought the problem came from there. I tried placing ORBX above France VFR in priority but that didn't work. I then tried deactivating the France VFR scenery but no luck there either. What must I do to get my buildings back? Link to comment Share on other sites More sharing options...
jlsaghaa Posted June 4, 2014 Share Posted June 4, 2014 change order is not enough : it is the autogen file that is modified; Perhaps uninstall France VFR ... but not sure. Personaly i use France VFR on FSX .... and ORBX on P3D ...... Link to comment Share on other sites More sharing options...
Holger Sandmann Posted June 4, 2014 Share Posted June 4, 2014 Hi there, have you tried cycling FTX Central back to Default once and then again to North America, pressing Apply each time? If that doesn't do it re-install the current Orbx Libraries from our support page and try again. If you don't have FTX Global then setting FTX Central to Default before installing an add-on like VFR France should allow you to use both, meaning NCA with FTX Central set to North America and VFR France with FTX Central at Default. Cheers, Holger Link to comment Share on other sites More sharing options...
FentiFlier1 Posted June 4, 2014 Author Share Posted June 4, 2014 Thanks for your help Holger. I uninstalled France VFR, then switched FTX central to default, re-installed F.VFR and I can now switch between the two sceneries thanks to FTX central. Great. Thanks again for the fast and efficient support! Cheers, Owen. Link to comment Share on other sites More sharing options...
Holger Sandmann Posted June 4, 2014 Share Posted June 4, 2014 Hi Owen, good to hear, glad I could help. Enjoy NCA! Cheers, Holger Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.