winged Posted March 4, 2014 Share Posted March 4, 2014 When I approach San Francisco I get an OOM message. I watch my resource manager RAM counter go from 3.1 to 3.7 as the sim starts to load the Bay area, and then I get the OOM. I reduced my autogen to none and this still happens. My Flightsim continues to operate, but not with full functionality, and my frames drop to 4-5. Anyone else notice this problem or is it just my system? I use other FTX areas with no problems at all, and the rest of NCA seems fine. Link to comment Share on other sites More sharing options...
kiwi stu Posted March 4, 2014 Share Posted March 4, 2014 Same with me,depending on what aircraft I am flying Stu Link to comment Share on other sites More sharing options...
keino333 Posted March 4, 2014 Share Posted March 4, 2014 I've flown from T2G MCO to NCA and FB SFO in the Qwings 757 using DX10 and I will share that I've had to save, exit and reload before reaching the target destination. (Autogen at Dense, LOD4.5, Rex4, and ASNxt - FTXGlobal) Link to comment Share on other sites More sharing options...
winged Posted March 5, 2014 Author Share Posted March 5, 2014 Solved! Both US Cities San Francisco and Flightbeam KSFO were active in the scenery library along with NCA. Just too much for my system. Unchecked them and all is good. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.