RESOLVED Program error and wrong elevation after isntalling orbxlibs 130909

[AndreaD]

Everything was ok, then I installed the new libs and now when switching regions in FTX central I get this error: 

 

RenameUniqueFiles: Could not complete operation since a file already exists in this path

 

D:\P3D\scenery\world\scenery\ADE_FTX_PNW_2WA1_elevation_adjustment.bgl

 

I launched P3D just the same, tried to position at Jackson Hole but the elevation data is obviously wrong (same as when you go to an orbx airport without selcting the right area in FTXCentral.

 

Any hint?

[Wolter van der Spoel]

Hi Andrea,

 

go to your => D:\P3D\scenery\world\scenery folder and look for the => ADE_FTX_PNW_2WA1_elevation_adjustment file, chek if there are not two of them, one with a .bgl extension and one with a .off extension, if you have FTX Central set to NA then the extension of the file should be .bgl if that is not the case and you have only one file with that name and a .off extension then rename it to .bgl

[AndreaD]

I fixed it with a bit of diy 30 minutes ago: just switched to Australia and deleted the offending bgl file, then switched back to US and that fixed it

 

tnx

 

Andrea