papabb Posted July 2, 2013 Share Posted July 2, 2013 \Purchased SCO \ Updated England & Wales with the new patches-FTX Central was set to Europe \Installed SCO \Today ran new Libs \Mesh set to 10mm \Autogen set to normal \ Also ran UTX Europe desktop icon to verify UTX was installed I have uninstalled and re-installed twice with same results Looking at the pictures(landing on 24 at Edinburgh) compared to others at the screen shot forum it looks like I am running GEX Europe(I have GEX Europe on my computer) not ORBX Scotland, plus I have trees in the apron at Edinburgh( see pic attached) FTX Central was set to Europe for these pictures Ideas? Rick Link to comment Share on other sites More sharing options...
Ripcord Posted July 2, 2013 Share Posted July 2, 2013 That doesn't look much like the FTX rendition of Edinburgh airport. Clearly you are missing an autogen exclusion area there Link to comment Share on other sites More sharing options...
Sam Hudson Posted July 2, 2013 Share Posted July 2, 2013 Hi papabb,Looks like you've got another scenery installed over the top of FTX Scotland. If you go into you scenery library in FSX options and make sure that FTX Scotland is at the top of the list (control this by selecting the 4 folders for Scotland and press the Move up button.) This should fix your problem, If it doesn't let us know and we'll take another look for you! Link to comment Share on other sites More sharing options...
Phil Manhart Posted July 2, 2013 Share Posted July 2, 2013 To add to what Sam said, make sure that when FTX Central is set to Europe, that any GEX folders are below all of the FTX entries in the scenery library just to be sure. If you want to try and make sure it doesn't happen again, do the following: 1. Set FTX Central to Default 2. Open the injection points tool in FTX Central. 3. Select the highest point in the scenery library (normally the very first, or top, entry) 4. Select that as the injection point. 5. Cycle FTX Central to Europe 6. Verify the scenery library has FTX entries above all else. Link to comment Share on other sites More sharing options...
papabb Posted July 2, 2013 Author Share Posted July 2, 2013 Thanks or the responses I will give a try and report back! Rick Link to comment Share on other sites More sharing options...
papabb Posted July 2, 2013 Author Share Posted July 2, 2013 That solved the problem! Thank you for your quick support on this issue! You can close this thread as Resolved! Thank you again... Rick Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.