Emile139 Posted December 3, 2020 Share Posted December 3, 2020 Hello, After a disk crash I had to reinstall Win 10 from scratch (most of important data gone..) after I installed P3d V5.1 hf1 I tested P3d V5 and it seams OK, after I started Orbx direct and downloaded and installed the products I use. I used the recommendations ( if you had everything inside the P3D folder, then Global Base must be uninstalled and installed again. You must run Verify files for all open LC products. You must run verify files for the Orbx Libraries. For good measure, also run Sync Simulator. To find Sync Simulator, Click Settings -> Help -> Sync Simulator.) I tested P3D V5 and it seams ok I look at the scenery config in the P3D Options I do not understand Orbx 3 image threre is a jump from area 003 to layer 13? Why? Orbx 1 image Orbx sceries are present Orbx 2 The same Orbx sceneries are again present and not selected ... So what did I wrong ??? How to solve Please I need some help Thanks in advance Emile EBBR Link to comment Share on other sites More sharing options...
Nick Cooper Posted December 3, 2020 Share Posted December 3, 2020 Hello, you appear to have created your own scenery library entries. You could try renaming your scenery.cfg file and then run P3D to create another one. Then close P3D and run either the Insertion Point tool or Sync Simulator and let Orbx Central insert the entries instead. Link to comment Share on other sites More sharing options...
Emile139 Posted December 4, 2020 Author Share Posted December 4, 2020 Hi nick, I have done as suggested (Sync simulator) and it seams OK now. Except in the scenery.cfg ... starting with the entry Area 4 I will change the information manually Thanks scenery.cfg Link to comment Share on other sites More sharing options...
Nick Cooper Posted December 4, 2020 Share Posted December 4, 2020 Hello, yes, that looks much better. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.