Juanjo Posted June 9, 2020 Share Posted June 9, 2020 I had not been flying with P3Dv4 for several days, but when I tried to make a flight today, the following message appeared when opening the simulator: Path not found F: \ P3Dv4 \ C: \ Users \ My name \ Orbx Library \ p3dv4 \ AU Australia v2 \ Orbx \ FTXAUv2_05_SCENERY \ * _ objectflow.xml ... and I can't find which instance asks for that file. As you can see, that path is misspelled by putting F: \ P3Dv4 \ and the rest at the same time F: \ P3Dv4 \ is the path where the simulator is installed Can you help me find where to make the necessary changes so that this error disappears Thank you J J Gómez Prieto IVAO 142928 Link to comment Share on other sites More sharing options...
Tarval Posted June 9, 2020 Share Posted June 9, 2020 Hello! It happens the same to me. I have P3 D V4.3 and automatically update Australia V2 .. at first it was denied and frame error then it was updated. Later when starting the P3D I got the message (see attached photo). Now every time I start the p3D I have to give it ok to load the program. What happens? Link to comment Share on other sites More sharing options...
BernieFlyer Posted June 10, 2020 Share Posted June 10, 2020 There is a simple fix for this. Check out the posts a a few entries down re Australia V2 Error. Essentially you remove a file and run Sync. It is outlined in detail in the posts. Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted June 10, 2020 Share Posted June 10, 2020 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.