AndreaD Posted April 14, 2010 Share Posted April 14, 2010 I get an error while runing FTX central: when I try to switch areas it complains about a .Net error: apparently it's unable to access the restore.bat file. It doesn't happen consistently, just most of the times. I am running Windows 7 64 bit Tnx Andrea Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted April 14, 2010 Share Posted April 14, 2010 Ciao Andrea, Did you try rightclick the icon and run the FTXCentral as Administrator ? Link to comment Share on other sites More sharing options...
AndreaD Posted April 14, 2010 Author Share Posted April 14, 2010 Yup first thing I tried, to no avail. And it's quite erratic: sometimes you get the error, other (rare) times you don't... a programmer's nightmare Bye Andrea Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted April 14, 2010 Share Posted April 14, 2010 I also may assume that you have UserAccountControl (UAC) switched off ? Link to comment Share on other sites More sharing options...
AndreaD Posted April 16, 2010 Author Share Posted April 16, 2010 Uhm.... it's Windows 7 and I have admin privileges..... but if it were a privilege issue it should go wrong every time..... so I think that's ruled out... that's why I think it's a tricky one. Bye Andrea Link to comment Share on other sites More sharing options...
AndreaD Posted April 21, 2010 Author Share Posted April 21, 2010 SOLVED: Win XP SP3 Compatibility mode takes the biscuit Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted April 21, 2010 Share Posted April 21, 2010 Good to hear you go it sorted Andrea Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.