PATCO Posted August 12, 2019 Share Posted August 12, 2019 Where do I find it? Link to comment Share on other sites More sharing options...
Jack Sawyer Posted August 13, 2019 Share Posted August 13, 2019 Hi PATCO and welcome to the forums! I saw your post and went right to it, here’s the way to get to it: Run Central of course, go to Global Range > Global VECTOR >click on Configure on the right under Options. Hope this helps. Best regards. Link to comment Share on other sites More sharing options...
dcongram Posted August 13, 2019 Share Posted August 13, 2019 Thanks Jack Sawyer.... That was one of my questions too. Link to comment Share on other sites More sharing options...
Jack Sawyer Posted August 13, 2019 Share Posted August 13, 2019 8 minutes ago, dcongram said: Thanks Jack Sawyer.... That was one of my questions too. You’re very much welcome sir! Best regards. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.