active Vector vs. FSDG St. Lucia P3D V4 - elevation issue

[chudobja]

Hello,
I have noticed a big sea-elevation issue after installing the FSDG St. Lucia airports (please look at attached pictures).
I tried to:
Uninstall-reinstall - no change
Inactivate the ORBX Vector TLPL and TLPC bgl files - no change

When I uninstalled the St. Lucia scenery completely, the problem was gone.

 

I have contacted FSDG many times, however, they say they do not have experience with such issue and that the problem must be coming from different addon.

 

After many attempts I found a complicated, but provisionally working solution.
There must be a massive conflict with ORBX Vector.

Using the Lorby-SI AddonOrganizer_P3D_V4, I tried to move the addon lower and lower down the scenery library (in case of Lorbys tool there is visible and adjustable the mix of both addons and regular scenery library). Finally, I made a discovery that if I put St. Lucia bellow the Vector (look at attached picture) and on top, make the Vector files ABP_TLPC.bgl and
ABP_TLPL.bgl inactive, the problem is gone.

A little complication is, that after running the FTX Global Vector Configuration Tool (e.g. after new scenery installation) I have to open Lorbys tool and put St. Lucia below Vector again.

Is there any way how to solve the conflict, please?

 

Thank you,

Jan

[Nick Cooper]

Hello,

FTX Central does not move the Vector entries.

The FTX Global Vector Configuration Tool does not touch the scenery library.

If you need to install a new airport, just check if it looks as it should

and if you think that Vector AEC is affecting it, disable AEC just for that airport.

You can save your changes in a profile.