xxd09 Posted January 30, 2019 Share Posted January 30, 2019 I have a “hole” at the apron at UT25 airstrip Monument Valley Everthing else OK I had this fault before and mended it but have forgotten how Any body help-remind me what I did? xxd09 Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted January 30, 2019 Share Posted January 30, 2019 Hi Maybe a screenshot would provide us with some clues? Link to comment Share on other sites More sharing options...
xxd09 Posted January 30, 2019 Author Share Posted January 30, 2019 Thanks for prompt reply Doug I remembered what I did! I ran Global Vector AEC tool-disabled UT25 and good to go Is this just a peculiarity of my particular P3D setup or if not should Orbx flag this in the installation instructions of this scenery? xxd09 Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted January 30, 2019 Share Posted January 30, 2019 2 hours ago, xxd09 said: Is this just a peculiarity of my particular P3D setup or if not should Orbx flag this in the installation instructions of this scenery? Thanks, and no, just running the Vector AEC tool has always been advised when making any changes, additions or omissions. Link to comment Share on other sites More sharing options...
xxd09 Posted January 30, 2019 Author Share Posted January 30, 2019 Does running the Vector tool automatically disable airports that require this procedure? I seem to remember that Palm Springs needed to be “disabled “ to run properly but that this info was flagged up at installation I had upgraded from P3Dv4.3 to 4.4 which probably caused the problem xxd09 Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted January 30, 2019 Share Posted January 30, 2019 Most are adjusted automatically, but some do need to be done manually. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.