resolved Melbourne scenery not loading correctly

[kiwikid1298]

Can someone help me with this , i have a lot of scenery etc from Orbx and Melbourne will not load correctly, i have attached screenshots to show what is happening.

Aircraft on runway face's grass wall, seems like it is inside the ground, all my other scenery is OK. I have this same thing last time with Friday harbor and had to purchase again.

Would appreciate help,

Thanks

Orbx Simulation Systems Pty Ltd
PO BOX 413 Toowong QLD 4077 Australia
ABN 59 120 838 244

The products you ordered have been added to your account.

Your transaction ID / receipt number is 5990cb92a642b.

YMML Melbourne International Airport V3

x1

$20.77 AUD

[Nick Cooper]

Hello,

 

thank you for the transaction number.

 

For YMML to display correctly, requires Vector AEC to be disabled.

You can find the Vector control panel by opening FTX Central, clicking

on the Vector icon and then on Control panel.

 

Did you perhaps previously buy Friday Harbor from Steam?

[kiwikid1298]

Thanks for the reply,

Yes i purchased from Steam then it did not work and had no help from them so decided to purchase direct from Orbx which worked fine, will try what you told me and get back,

Thanks, is this what it should look like?

Thanks,

Raymond

[kiwikid1298]

Yes i did that but seems i still have same problem

[Nick Cooper]

I think you will need to try again.

Did you click on Apply and wait for the notification that the process was successful?

[kiwikid1298]

Sorry i had to go out, you were correct i may have not clicked on apply, redid it again and all is working ok, thank you so much, will continue to use the vector check each time i  need to, probably that was the problem i had with the Friday Harbor install from Steam but no one from steam or Orbx would help me, once again thankyou!