EastCoastCanadian Posted April 5, 2016 Share Posted April 5, 2016 Good day, I've been trying to reinstall ORBX NA in P3D v 3.2. All runs fine with the installation but when I fire up P3D it tells me that NA 1 is not found and do I want to remove it. I've tried numerous times with downloading and installs but I keep getting the same error. Any help is greatly appreciated Link to comment Share on other sites More sharing options...
Jon Clarke Posted April 5, 2016 Share Posted April 5, 2016 When you get that message if you click on NO does it then come up again and tell you NA 2 is not found. If it does it sounds like the install did not go through properly. I also assume you ran the installer after you "unwrapped" it and not from the zipped file, installed orbxlibs after the install, then switched region a couple of times in Central, then chose North America region? Link to comment Share on other sites More sharing options...
EastCoastCanadian Posted April 5, 2016 Author Share Posted April 5, 2016 Ok thanks for the reply I'll try it again see what happens Link to comment Share on other sites More sharing options...
Penzoil3 Posted April 24, 2016 Share Posted April 24, 2016 Check this- Link to comment Share on other sites More sharing options...
EastCoastCanadian Posted April 24, 2016 Author Share Posted April 24, 2016 Thanks well I'm glad that is sorted I never did get a solution until now thanks Penzoil3 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.