xxd09 Posted January 4, 2015 Share Posted January 4, 2015 Hi All I just installed Monument Valley Scenery-all terrific stuff but I have a "hole" in the rear of the Airport apron -affects about a third of the surface. The surface of the apron seems to have sunk-a mesh issue? I avoid it on take off but it is a little frustrating Would appreciate any help It may not be relevant but I have the same issue with Grand Canyon Ãirport which comes with the Grand Canyon Scenery. Something to do with this area on my flightsim-Utah/Arizona ? xxd09 Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted January 4, 2015 Share Posted January 4, 2015 Was FTX Central set to NA prior to install ? Did you run the latest library files after the install ? Did you run the Vector tool after installing USMV and Grand Canyon ? Link to comment Share on other sites More sharing options...
Larry Hickerson Posted January 4, 2015 Share Posted January 4, 2015 Got to be the install! Wolter is dead on target. A wonderful piece of "Art" this is! Kudos to the developer. Link to comment Share on other sites More sharing options...
Wolter van der Spoel Posted January 4, 2015 Share Posted January 4, 2015 Good to hear it's working there, be aware that the Grand Canyon and Death Valley are only summer versions Link to comment Share on other sites More sharing options...
xxd09 Posted January 4, 2015 Author Share Posted January 4, 2015 Hi Walter Thanks for the prompt reply. Yes -did all those things. Yosemite installed perfectly . Must be a particular problem of my system xxd09 Link to comment Share on other sites More sharing options...
xxd09 Posted January 4, 2015 Author Share Posted January 4, 2015 Hi All Got it sorted-Monument Valley that is. Ran Vector tool again but rather than use it in a general way I ran the Airport Elevation Correction-Auto Correction tool. This worked but Grand Canyon Airport remains recalcitrant! xxd09 Link to comment Share on other sites More sharing options...
xxd09 Posted January 4, 2015 Author Share Posted January 4, 2015 Hi All Reading further about Configurator Tool in an relevant post here I returned once again to the FTX Vector Configurator Tool and found and manually disabled Grand Canyon Airport elevation(AEC) Bingo! Airport is good. Don't you love this Forum and its posters! xxd09 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.