hwh86 Posted November 29, 2014 Share Posted November 29, 2014 I have just purchased and installed Canberra City Scape and YSCB Canberra Airport, I have been saving up for these two for some time. Imagine my surprise when I started looking around flying the Trike and discovered that Parliament House is still floating mid air, just like it was reported much earlier as a Vector problem, if I remember correctly. I have both Holger Mesh and Pilots Global 2010 FTX, I have Vector 120 and all other patches are up-to-date. I have run the latest ORBXLIBS program. Can someone please give me a clue as to what is happening? I am a pilot and my computer skills and knowledge extend only to running FSX and flying aeroplanes. Link to comment Share on other sites More sharing options...
hwh86 Posted November 29, 2014 Author Share Posted November 29, 2014 Should I have posted this in the Vector Support category too? If so, please forgive me and move it over. Link to comment Share on other sites More sharing options...
Holger Sandmann Posted November 29, 2014 Share Posted November 29, 2014 Hi there, if you have both FTX AU and Global Vector then it's best to deactivate the Vector entries while flying in Australia; see http://www.orbxsystems.com/forum/topic/79748-does-vector-alter-full-fat-areas/#entry731244 Cheers, Holger Link to comment Share on other sites More sharing options...
hwh86 Posted November 29, 2014 Author Share Posted November 29, 2014 Hi Holger, Thank you for the explanation, very concise and clear. I have discovered the same thing by trial and error, it is a minor inconvenience but c'est la vie. Thanks again, Kind regards, Les Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.