Barney banana Posted May 4, 2014 Share Posted May 4, 2014 Hi, I am running P3D v2 and have just downloaded YMML for P3D v 2 I already have FTX AUS SP4 Avalon and Essendon airports, FTX global and have just installed Orbx libs for P3D v2 all the other airports work fine but at Melbourne my aircraft sits in a hole on the runway, I can see other objects above me!! It's like I'm in a sink hole I can see the runway directly in front but it runs into a dirt wall!! I even tried a flight from Avalon to Melbourne int. all fine till I touched down an fell int a hole, Any ideas? Link to comment Share on other sites More sharing options...
alan2 Posted May 4, 2014 Share Posted May 4, 2014 My experience too . Link to comment Share on other sites More sharing options...
spak Posted May 4, 2014 Share Posted May 4, 2014 Yep! have got the same problem all the taxiways and the start of runway 34 are sunken have taken a screen shot, just got to find out how to get it in my post. my sig is probably not up to date but my Order No: for YMML is FSS0077297 Spak Link to comment Share on other sites More sharing options...
Holger Sandmann Posted May 4, 2014 Share Posted May 4, 2014 Hi guys, the Orbx YMML add-on doesn't change the default elevation of 434ft so it sounds as if you have a conflicting add-on or file active that does alter the elevation. If you're using FTXG Vector make sure you run its auto-configuration tool, which should find and deactivate any Vector YMML files. Cheers, Holger Link to comment Share on other sites More sharing options...
alan2 Posted May 4, 2014 Share Posted May 4, 2014 Thank you Holger . Ive been out of the loop lately and need to reaquaint myself with some things Link to comment Share on other sites More sharing options...
hirail22 Posted May 5, 2014 Share Posted May 5, 2014 That's fixed it, thanks for your help. Link to comment Share on other sites More sharing options...
spak Posted May 5, 2014 Share Posted May 5, 2014 Disabled YMML AEC in the FTXG Vector configuration tool all good now. Although I couldn't find the auto configuration tool. Thanks Holger Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.