mnowinski Posted December 17, 2013 Share Posted December 17, 2013 I was making a flight out of Oakland, Ca. to Hawaii yesterday and noticed that all the water textures in the SanFran Bay area had been changed to land textures. Here's a photo with KOAK on the right side. http://i.imgur.com/xLQTKFZh.jpg I tried resetting the area with FTX Central and used both Hybrid and Non-Hybrid modes with no success. The only thing I have added in the last week or so was Aerosoft's X-Cities - Los Angeles. I haven't had this anomaly since I installed it until yesterday. I also tried deactivation of that scenery with no success either. Tried flushing the cache with FTX Central as well. Any other suggestions to try? Thanks, Link to comment Share on other sites More sharing options...
Holger Sandmann Posted December 17, 2013 Share Posted December 17, 2013 Hi Mike, if you're using Ultimate Terrain X USA start its setup panel. It will check and repair the custom terrain.cfg entries required for properly displaying water bodies. Cheers, Holger Link to comment Share on other sites More sharing options...
mnowinski Posted December 17, 2013 Author Share Posted December 17, 2013 Holger, Yes, I do have UTX USA and ran the setup panel.....and it WORKED!!! I have my water areas back to normal. Thanks very much. Cheers, Mike Link to comment Share on other sites More sharing options...
Holger Sandmann Posted December 17, 2013 Share Posted December 17, 2013 Hi Mike, good to hear and you're welcome. Cheers, Holger Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.