Dieter K. Posted November 27, 2020 Share Posted November 27, 2020 Hi there, after updating P3DV5 i get problems with each scenrey. i tried to sync the files, but there is no success. Any idea what`s going wrong Thanks for help greetings Dieter Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 27, 2020 Share Posted November 27, 2020 Hello, please have a look here. Link to comment Share on other sites More sharing options...
Dieter K. Posted November 29, 2020 Author Share Posted November 29, 2020 Hi Nick, i have done the steps by Veryfy files - rename the terrain cfg - start and shut down PsdV5.1 - run the hel/sync, but i get still the same problem with the textures is rhere any other possibility to match scenry without misplaced titles. Thx Dieter Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 29, 2020 Share Posted November 29, 2020 Hello, the key file is scenery\base\scenery\iclookup.bgl. Rename that, run verify files for the Orbx Libraries and try again. Link to comment Share on other sites More sharing options...
Dieter K. Posted November 30, 2020 Author Share Posted November 30, 2020 Hi Nick, I have done all the options, but unfortunately still no success Here my last sreen shot after rename scenery\base\scenery\iclookup.bgl and run verify files for the Orbx Libraries. Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 30, 2020 Share Posted November 30, 2020 Hello, is this everywhere or just in one or a few locations? Something is evidently interfering with the landclass definitions, causing the wrong textures to respond to the calls for display. In general, once all the correct textures are in place, achieved by Verify files, the terrain.cfg file has the correct Orbx entries added to it and the lclookup.bgl file is the Orbx version, 52 kb in size, then this problem typically goes away. It can be caused by other developers adding their own lclookup.bgl file and their own landclass. Mostly though, those effects are local to the product in question, unless of course they are also products that change textures and landclass globally. Link to comment Share on other sites More sharing options...
Dieter K. Posted December 1, 2020 Author Share Posted December 1, 2020 Hello Nick, the most scenery problems exists in Gen/Ges area. i have new build lclookup.bgl file in the scenery folder. but whats with scenery config? my insertion point is set to nantes atlantique greetings Dieter Link to comment Share on other sites More sharing options...
Dieter K. Posted December 8, 2020 Author Share Posted December 8, 2020 Hi Nick, i found the problem and i think it was my own mistake. the insertion point ofGlobal open LC was wrong, so this was the mistake. Thanks for the support and have a good time. cheers Dieter Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.