Ken Williams Posted February 8, 2020 Share Posted February 8, 2020 P3D V4.5, to install Vector... YES OR NO ???? Link to comment Share on other sites More sharing options...
Nick Cooper Posted February 8, 2020 Share Posted February 8, 2020 Hello, your choice, I am not sure that I understand the question. Link to comment Share on other sites More sharing options...
Ken Williams Posted February 8, 2020 Author Share Posted February 8, 2020 Thanks nick, I have used Vector in my last install and had Black spots every wear, No i have Clean install and i no black spots. Link to comment Share on other sites More sharing options...
Nick Cooper Posted February 8, 2020 Share Posted February 8, 2020 Vector can cause black areas in water, as I am sure you know, however it does not contain any textures and cannot therefore fail to display them on land. Black where there should be textures is mostly caused by a mismatched lclookup.bgl file or a problem in the terrain.cfg file. Link to comment Share on other sites More sharing options...
Ken Williams Posted February 8, 2020 Author Share Posted February 8, 2020 Thanks Again, Maybe i will install later. Now to set up the Options Panel to the right specks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.