Ed Koorevaar Posted November 10, 2019 Share Posted November 10, 2019 Hi to you all! Working for years now seamless with ORBX and especially with the old FTX Central. I believe ORBX central is for me complicated. Today I flew to ESSA. I think the first time after the change to ORBX Central. It scared me for what I saw. All asphalt on and around ESSA missed their layers. Buildings seems to be untouched. I first started the elevation configuration. I found it strange that it was ready in about 10 seconds, for normally it took overhere some minutes. But perhaps less time because of the new orbx central. No change So I re-installed ESSA. No change. Does anyone of you what is wrong or what Imight have done wrong? Thanks for any replies! Regards, Ed Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 10, 2019 Share Posted November 10, 2019 Hello, this airport does not work as intended unless the customer has only one working copy of Objectflow installed. Link to comment Share on other sites More sharing options...
Ed Koorevaar Posted November 10, 2019 Author Share Posted November 10, 2019 Hi Nick thaks for your very fast reply. Can you tell me how I can do this, please? Thanks, Ed Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 10, 2019 Share Posted November 10, 2019 Hello, first make sure that you have removed the FTX Central version by deleting the Objectflow 2 folder from Documents\Prepar3D v4 Add-ons\. Then install Objectflow from the list of products in Orbx Central. Link to comment Share on other sites More sharing options...
Ed Koorevaar Posted November 10, 2019 Author Share Posted November 10, 2019 WOW Thanks Nick! Have a look at the image. Iwould never had found your solution. Do I have to run the elevation configuration now again? All the best, Ed Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 10, 2019 Share Posted November 10, 2019 Hello, no need. Link to comment Share on other sites More sharing options...
Rebollo19 Posted December 14, 2019 Share Posted December 14, 2019 Thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.