Oliver Burchardt Posted August 18, 2019 Share Posted August 18, 2019 Dear all, I have bought the KMRY yesterday and I only see this when I load the airport: It looks like there had something been loaded but not entirely. What have I done so far: - Un- and reinstall the scenery - Uninstall again - Update the NC scenery - Reinstall KMRY Of course I have used AEC but to no avail. I am running out of ideas what is happening. Oliver Link to comment Share on other sites More sharing options...
Nick Cooper Posted August 18, 2019 Share Posted August 18, 2019 Hello, the most likely cause is that objectflow is not working. Did you install the Orbx libraries? Link to comment Share on other sites More sharing options...
Oliver Burchardt Posted August 18, 2019 Author Share Posted August 18, 2019 Hi, Yes, I did. The problem is even more severe than I thought. I do not see any airport scenery with three exceptions (EDDK, EDDF and KJAC). All other airports do not have any buildings at all. So, I do not know if this problem stems from any ORBX product as it happens also in areas for which I have no ORBX scenery installed. Complete mystery to me. Oliver Link to comment Share on other sites More sharing options...
Nick Cooper Posted August 18, 2019 Share Posted August 18, 2019 I wonder if your scenery complexity slider is set too low? Link to comment Share on other sites More sharing options...
Oliver Burchardt Posted August 18, 2019 Author Share Posted August 18, 2019 You were wondering correctly. But the solution was too easy for me apparently. Thanks for the help! Link to comment Share on other sites More sharing options...
Nick Cooper Posted August 18, 2019 Share Posted August 18, 2019 No problem. Welcome to the forums. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.