dfeldman Posted October 25, 2017 Share Posted October 25, 2017 Hope this is the right place to post this. KBZN P3DV4 not 4.1 with latest libraries. Dave. Link to comment Share on other sites More sharing options...
Nick Cooper Posted October 25, 2017 Share Posted October 25, 2017 Hello Dave, I have split this from where you added it. However, I cannot replicate the problem. Link to comment Share on other sites More sharing options...
dfeldman Posted October 25, 2017 Author Share Posted October 25, 2017 Ok thanks Nick. Could re-installing the ORBX libraries help? Dave. Link to comment Share on other sites More sharing options...
Nick Cooper Posted October 25, 2017 Share Posted October 25, 2017 Anything's worth a try. Link to comment Share on other sites More sharing options...
chrisdev01 Posted February 12, 2019 Share Posted February 12, 2019 (edited) I know this is an old thread, but I have exactly the same problem at KBZN, trees all over the taxiways etc. I have ORBX Base, openLC NA, Vector, ORBX Trees, ORBX CRM, and I have installed the ORBX freeware Global Airport pack. I am not using the payware ORBX KBZN. Is anyone else experiencing this and if so, have you found a fix? Thanks, Chris Edited February 12, 2019 by chrisdev01 Link to comment Share on other sites More sharing options...
jimcarrel Posted February 13, 2019 Share Posted February 13, 2019 I run into several runways with numerous trees in Orbx regions. It's because of setting auto gen rather high. If I know I'm going to use one of those airports I set the auto gen to Normal (at least until i've landed or taken off) I have had some that this procedure still have a few trees leftover. I think it just goes with the P3D territory (pun intended) Link to comment Share on other sites More sharing options...
Recommended Posts