mjj55409 Posted April 28, 2016 Share Posted April 28, 2016 I like to fly the A2A Cub from airport to airport and then save the flight so that the plane is as I left it. When I do that with the Northern California region active, the ATC window only has options for the airport at which I started (which could have been 12 - 15 airports ago). So I can't use the ATC window to dial up ATIS for a weather check. I cannot even manually tune in ATIS. However, I I open the same plane at the same airport without using a saved flight, the ATC window and ATIS works as expected. Any clues? Link to comment Share on other sites More sharing options...
Stewart Hobson Posted April 28, 2016 Share Posted April 28, 2016 Hi there. Try updating the time/date after you load up your saved flight. FSX probably thinks you're still on the original flight. I've done what you are suggesting and haven't had that problem. Another possibility is that you haven't programmed in a direct flight, since the Cub doesn't have a GPS, so again, FSX thinks you're still on the original flight. Link to comment Share on other sites More sharing options...
mjj55409 Posted April 28, 2016 Author Share Posted April 28, 2016 I'm sure that was it, but I wasn't sure how to reset it. But then, it just started working again. So all is well. Thanks. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.