veldthui Posted December 21, 2015 Share Posted December 21, 2015 I recently install P3D V3 and have been flying around NZ with no issues. I have Global, Vector, Oceania, and YMML installed. Today I did a flight from YSSY to YMML. YSSY was all good and no issues and the ground looked okay the whole flight. As I flew into YMML I could see the ground was all skewed up and that there were big holes in the ground everywhere. I landed and the ground was way below the runway and I got stuck in the ground. Tried it with Global as the active and same thing. Oceania active, no difference. Was going to un-install YMML but could not see how to. I new download of the ORBX libraries came in before I flew and before I started P3D. Order numbers FSS0383479, FSS0383468, FSS0385354 in case I can't work out the sig. Link to comment Share on other sites More sharing options...
veldthui Posted December 21, 2015 Author Share Posted December 21, 2015 Okay it is definitely Orbx YMML that is the issue. I disabled it in the Scenery library and it is fine with the default scenery for YMML. Re-Enable it and big holes again. Link to comment Share on other sites More sharing options...
petfy Posted December 21, 2015 Share Posted December 21, 2015 Apply AES(?) in Vector to YMML. Link to comment Share on other sites More sharing options...
Luke Stirling Posted December 21, 2015 Share Posted December 21, 2015 What mesh are you using? Have you tried the freeware Holgermesh for the region? Link to comment Share on other sites More sharing options...
veldthui Posted December 21, 2015 Author Share Posted December 21, 2015 2 hours ago, petfy said: Apply AES(?) in Vector to YMML. This fixed it. Ran the autoscan and it found 4 NZ airports and 2 Australian 1 of which was YMML. Outting it on the disable side fixed the issue. Thanks. Link to comment Share on other sites More sharing options...
veldthui Posted December 21, 2015 Author Share Posted December 21, 2015 2 hours ago, paralipsis said: What mesh are you using? Have you tried the freeware Holgermesh for the region? Standard mesh but was going to use FSGlobal X Link to comment Share on other sites More sharing options...
Penzoil3 Posted December 21, 2015 Share Posted December 21, 2015 Let me mention, that a YMML P3D3 installer hasn't come out yet. Any other installation method is not supported. If you wait, eventually a YMML installer wiil come out. In the mean time, you create your own problems. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.