[Orbx GA Traffic into 5.3]

Good morning,

I’m currently flying only GA in 5.3

I’m really missing the GA package that worked in 4.x

Is there a way to bring that in, or increase GA traffic in general?

I would consider building my own flight plans (if that’s the correct description) but not sure where to start.

Thanks,

Mark

[KRDD hangs on install.."Finalizing and Cleaning up..."]

Hi Nick-

I got it. Backups set to NAS because I'm low on drive space.

NAS was off, hence could not complete full install.

All is well.

Cheers,

Mark

[KRDD hangs on install.."Finalizing and Cleaning up..."]

Ok.

However, I can’t configure anything.

When I open KRDD it will attempt to complete the install.

[KRDD hangs on install.."Finalizing and Cleaning up..."]

Here you go Nick, thanks.

central.log

[KRDD hangs on install.."Finalizing and Cleaning up..."]

Hi all,

 

Trying to get KRDD installed but not much luck.

It hangs indefinitely on finalizing and cleaning up.

Any ideas on what's causing this. I have a lot or Orbx scenery and have never seen this one before

 

Mark

[One library for both V4 and V5?]

Thanks.

[One library for both V4 and V5?]

I want to run V4 and V5 side by side. Have not installed V5 yet.

Is it possible to 'share' the scenery/airport library between the two?

 

Thanks,

Mark

[KRDD- too many taxi signs]

I don't know where to look for an additional addon that I don't think I have?

I'm using TE Norcal. Would something in that scenery cause this? An airport added by TE?

[KRDD- too many taxi signs]

Here you go...

 

[KRDD- too many taxi signs]

I will and thank you.

 

Mark

[KRDD- too many taxi signs]

Hi-

After the V5 upgrade, I seem to have taxi signs everywhere. I checked in TE NCA scenery and see that some bgls have been disabled there 'by KRDD' so I'm not sure what's producing these extra signs.

[Thanks for KRDD!]

 

Mark

[YBCS runway black at night]

Apparently it has to be dark dark. :>)

This fixed it...

https://orbxsystems.com/forum/topic/201354-airfield-lights-ybcs/?do=findComment&comment=1719816

[YBCS runway black at night]

When I said the runway was black, I meant no lights. Not clear at all. My apologies.

I had already verified files prior to post, but did so again anyway, no luck.

I recently purchased Austrailia V2, would that figure into this?

Files attached.

[YBCS runway black at night]

Hi Doug-

It's the missing runway lights that I'm most concerned about.

[YBCS runway black at night]

Anybody?

[YBCS runway black at night]

Hello,

 

I just bought YBCS and flew from YBAS to YBCS.

Upon arrival at night, the runway on approahch was black and the landing lights of my Lear25 barely illuminated the runway. However, after exiting the runway onto the tarmac, landing and taxi lights showed up fine. Also, the aircraft was very dark under the airport lights. I'm on V5.1

 

Is this normal?

 

Thanks,

Mark

[True Earth North California is WAY TOO RED]

If you own Envtex/Envshade there is a saturation slider in there that makes the red very manageable.