newtie2
Members-
Posts
111 -
Joined
-
Last visited
Everything posted by newtie2
-
Good morning, I’m currently flying only GA in 5.3 I’m really missing the GA package that worked in 4.x Is there a way to bring that in, or increase GA traffic in general? I would consider building my own flight plans (if that’s the correct description) but not sure where to start. Thanks, Mark
-
resolved KRDD hangs on install.."Finalizing and Cleaning up..."
newtie2 replied to newtie2's topic in PREPAR3D® V4.x Support Forum
Hi Nick- I got it. Backups set to NAS because I'm low on drive space. NAS was off, hence could not complete full install. All is well. Cheers, Mark -
resolved KRDD hangs on install.."Finalizing and Cleaning up..."
newtie2 replied to newtie2's topic in PREPAR3D® V4.x Support Forum
Ok. However, I can’t configure anything. When I open KRDD it will attempt to complete the install. -
resolved KRDD hangs on install.."Finalizing and Cleaning up..."
newtie2 replied to newtie2's topic in PREPAR3D® V4.x Support Forum
Here you go Nick, thanks. central.log -
I don't know where to look for an additional addon that I don't think I have? I'm using TE Norcal. Would something in that scenery cause this? An airport added by TE?
-
-
I will and thank you. Mark
-
Hi- After the V5 upgrade, I seem to have taxi signs everywhere. I checked in TE NCA scenery and see that some bgls have been disabled there 'by KRDD' so I'm not sure what's producing these extra signs.
-
resolved YBCS runway black at night
newtie2 replied to newtie2's topic in PREPAR3D® V5.x Support Forum
Apparently it has to be dark dark. :>) This fixed it... https://orbxsystems.com/forum/topic/201354-airfield-lights-ybcs/?do=findComment&comment=1719816 -
resolved YBCS runway black at night
newtie2 replied to newtie2's topic in PREPAR3D® V5.x Support Forum
When I said the runway was black, I meant no lights. Not clear at all. My apologies. I had already verified files prior to post, but did so again anyway, no luck. I recently purchased Austrailia V2, would that figure into this? Files attached. -
resolved YBCS runway black at night
newtie2 replied to newtie2's topic in PREPAR3D® V5.x Support Forum
Hi Doug- It's the missing runway lights that I'm most concerned about. -
resolved YBCS runway black at night
newtie2 replied to newtie2's topic in PREPAR3D® V5.x Support Forum
Anybody? -
Hello, I just bought YBCS and flew from YBAS to YBCS. Upon arrival at night, the runway on approahch was black and the landing lights of my Lear25 barely illuminated the runway. However, after exiting the runway onto the tarmac, landing and taxi lights showed up fine. Also, the aircraft was very dark under the airport lights. I'm on V5.1 Is this normal? Thanks, Mark
-
active True Earth North California is WAY TOO RED
newtie2 replied to Howellerman's topic in PREPAR3D® V5.x Support Forum
If you own Envtex/Envshade there is a saturation slider in there that makes the red very manageable.