skypilot Posted February 3, 2011 Share Posted February 3, 2011 I have a CH yoke with one engine quadrant. How do I set it to control both engines (in a twin of course) using the one quadrant. It used to work some time ago with out a problem. I try the assignments in FSX setting but it seems you cannot map the one control to 2 engines. Link to comment Share on other sites More sharing options...
Derek McAllan Posted February 3, 2011 Share Posted February 3, 2011 You should be able to do it from FSX but if you get stuck download FSUIPC and assign the single throttle axis to map to both engine throttles in that. Derek Link to comment Share on other sites More sharing options...
Maurice_King Posted February 4, 2011 Share Posted February 4, 2011 Assign the Left and the right engine to the same control axis Link to comment Share on other sites More sharing options...
skypilot Posted February 4, 2011 Author Share Posted February 4, 2011 Assign the Left and the right engine to the same control axis That's what I tried but I had no luck - I have engine one mapped so I went to engine 2 but it did not recognise the input from the yoke. will try again Link to comment Share on other sites More sharing options...
Maurice_King Posted February 4, 2011 Share Posted February 4, 2011 No go further down the list and assign engines to so they both are controlled Unfortunatly tin this instance you cannot run independent speeds to assist in turning on the ground Link to comment Share on other sites More sharing options...
skypilot Posted February 4, 2011 Author Share Posted February 4, 2011 Thanks Got it when I went further down. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.