Stephan Wörmcke Posted June 11, 2019 Share Posted June 11, 2019 Dear Orbx support staff Following problem at YSSY. I de-install AU v1 and install via FTX central the new V2. In the final of RWY 16R or 16L i missed some buidings... IKEA-Building / Railroad-Freight depot and some other Buildings. unfortunately there are only a lot of black boxes on the ground ( see the pictures ) Any suggestions would be welcome. Best reagrds Stephan Wörmcke Link to comment Share on other sites More sharing options...
ijaz Posted June 14, 2019 Share Posted June 14, 2019 Hi You will need to ensure that Fly Tampa Sydney_LC is not ticked in your scenery library, also remove the Holgermesh if you have installed it with Australia V1 and finally ensure the Fly Tampa Sydney airport scenery is set to a higher priority than Australia V2. Link to comment Share on other sites More sharing options...
carg0 Posted June 18, 2019 Share Posted June 18, 2019 I have the same problem. No airport buildings after the update to Australia v2. Of course, before updating, I uninstalled Autralia v1 VIA FTX Central and I also disabled FlyTampa scenery. See the picture below of the no buildings situation in YSSY. I didn't change any graphics settings in P3D. All the same as it was before updating. To correct that situation I enabled again FlyTampa scenery and put it in top priority in the scenery library and now I have a decent scenery for the YSSY scenery. Is there a special setting in P3D or ORBX to be able see the airports building or the update is just like that ?? no buildings FlyTampa buildings Thank you ! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.