Jump to content

OpenLC autogen not loading


Recommended Posts

I have recently updated my P3D to V4.1 hoping my problem would be fixed, I have installed FTX global and then flew a flight (using a 737 up to 35,000ft) and when descending from cruise the autogen would load in around 20,000ft but I have now encountered the same problem with Open LC EU as now autogen will not appear until 5000ft and I have to either wait a long period of time on pause for the autogen to appear or reset the settings sliders for the autogen to reset. This only happens with Open LC?


Thank you in advance




Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...