red_SYSTEMS

I tried removing Vector from my system. Unfortunately, I now have the issue that the sim sometime start, sometimes not. When I open Prepar3D, I see the splash screen. And after a few seconds back to the desktop. No event viewer entry. Also tried deleting my Prepar3D.cfg file. I think roughly less than a quarter of the attempts to start succeed. In the moments P3D starts I still have the mesh issues at both YSNF and NZQN.

Between the moments I added this add-on and removed it I didn't made any changes. After removing YSNF freeware, I removed Orbx NZQN, verified the files of Global VECTOR and added Orbx NZQN back. NZWQ looks almost the same as screenshot 1 in my opening post. If you don't think its related I can open a separate topic for this.

I tried. Not an improvement at all...

Hello Nick, I tried removing this scenery files but then this airport looks like screenshot 2. I can't get it back to its default state. Richard

Hello everyone! I've a bit of a mesh issue at a freeware scenery airport I flew in few hours ago. It is Norfolk Island Airport, link is at the bottom of this post. I forgot to add this scenery to my library so I did this en-route. During approach, landing and parking everything was fine. Then I reloaded the sim as GSX somewhere during the flight stopped working. After reloading I noticed that the mesh is rising above some parts of the runway (screenshot 1). I checked the Airport Elevation Correction (AEC) and run the Auto-Configurator two times, bit this made no difference. Then I tried disabling this scenery. The airport sunk very deep in the ground (screenshot 2). Again, tried AEC settings but this made no difference. With, or without this freeware scenery I can't get this airport as it should. Tried enabling/disabling AEC; enabling/disabling this freeware scenery for this airport and all different combinations for a couple of hours. But the effect now is always either screenshot 1, or screenshot 2. How can I solve this? I prefer using this freeware scenery - I really want to revisit this island several times. But, if it's not possible how I can then get the default scenery back working? My Orbx add-ons: Global BASE Pack, Global VECTOR and Global openLC Europe. Richard -- Screenshot 1: Screenshot 2: Scenery freeware link: https://library.avsim.net/esearch.php?DLID=144089