[ESMX v0.9.0 - Darryl W]

I see that a testing section is now available. A bit late but after reviewing what has been posted so far I have only a few comments to make.

I did try to change the wind settings, I expected ATC to give runway 19, it did, but the guides always went to runway 01.

I did not try the RNP approaches although the charts suggested they are there.

I tried various settings for local traffic and there were only two aircraft shown.

Biggest issue is ATC.

 

Navigation - 
With Navigraph disabled there is only LOC 01 and ILS19
With Navigraph enabled there are also RNP approaches for 01 and 19.

Navigraph chart show runway length as 6910 but LNM shows 6904
Navigraph chart shows runway 19 as M187, 01 as M007
LNM does not show taxiway A/B
Variation 6E - 01 T013 - 19 T193

ILS19 M188
IAF D007L D12.0 2800 IF MX D10.0 2600  FAF FI19 2600 MX 109.70/187

DME            Actual
D007L D12 - D12.0
CI19  D10 - D10.0
FI19  D6.7- D06.7

 

PAPI - LOW ON FINAL
No ATC to Parking upon landing.

 

Gates/Parking CRJ700
6    78ft ATC - No taxiway ID (A) to 01 - Guides ok
8    78ft ATC - No taxiway ID to 01 - Guides ok

 

10    78ft Not aligned with taxiway. No taxiway ID to 01 - Guides ok

 

12    78ft Aligned with taxiway slightly skewed right. No taxiway ID to 01 - Guides ok

14    78ft Alignment ok - ATC No taxiway ID to 01 - Guides ok
16    78ft Alignment ok - ATC No taxiway ID (B) to 19 - Guides point to 01 with wind 180@18
18    78ft Alignment ok - ATC No taxiway ID (B) to 19 - Guides point to 01 with wind 180@18

 

Windsocks - Somewhat close to Navigraph Chart 10 MAR 23
01R N56 55.59 E14 43.81    N56.9265 E14.730167 - Actual N56.937154 E14.732831 - Direction ok
19L N56 56.19 E14 44.01 N56.9365 E14.7335 - Actual N56.927073 E24.730203 - Direction ok
 

 

[Idaho Fire Lookouts beta 1 - Darryl W]

I spent my time looking at the nuts and bolts; that is, what MSFS World Map showed versus Little Navmap. There appeared to be some issues.

A couple of airports seem to have runways reversed.

One airport has its parking spot at another airport.

Not all airports have windsocks - maybe as expected?

Strange behaviour when loading some airports at runway with the sim placing the aircraft at what appears to be the airport location point but then when the Fly button is pressed the aircraft goes to the runway.

Should some of the parking spots actually be helipads?

 

 IDAHO Fire Lookouts

 

IDSHE
World map has runway orientation reversed.

Start Prk 1 ok
On load Apr 26 2024 snowbanks show. Switch Live Weather off and on and no snowbanks
Windsock - OK

 

IDPPL
World map has no runway outline. Assume that this is correct due to landing locations seem to be parking locations?

Parking 1 near cabin. Smoke and animated flag seen.
No windsock seem.

 

IDMFL
P1, P2 ,Helipad. No runway starts in LNM.

No helipad to select on World Map
Car and deer seen at runway ends.
Outhouse seen.
No windsock seen.
Prk 2 near cabin seems to be for helicopter only.

 

IDSRP
On load snow seen. Toggle live weather and ok

Animated deer seen.
Runway 31 starts with engine on and severe upward slope
Animated hawk on top of cabin
No windsock seen
Reload at Parking 2 snow seen again.

 

IDBGB
World Map shows runways reversed from LNM (LNM wrong)
Prk 1 - Looks like helipad but too far fwd.

Prk 2 - At start of runway - ok
No windsock seen
Runway 19 Start - ok
Runway 01 Select initially on Tower location but then moves to Runway 19

 

IDPYP
Prk 1 - ok
Truck seen and cabin with flag and solar panels
Windsock - ok
Prk 2 - Near runway - ok
Short and inclined runway
Runway 12 start - ok
Runway 30 start - initial load on Tower then goes to runway.

 

IDTBM
Prk 1 - Snowbanks on load. Appears to be helipad
Prk 2 - Near end of runway - ok
Runway 36 - Initial start at Airport Location - Press Fly and goes to runway.

Initial load shows heli at Airport Location

Runway 18 - Initial start at Airport Location - Press Fly and goes to runway.
No windosck.

 

IDSMA
No parking spots on world map drop-down.
Select Prk 2 from map and list updates to show P1 and P2
Prk 2 near end of runway 20
Prk 1 Does not appear on World Map - On load starts at Prk1 at IDSML

Start Runway 02 - ok
Saw 3 pipers, tents and campfire.

 

IDSML
Prk 2 not on world map - starts at IDSMA Prk 2
Prk 1 is selectable on map. Not much room around it. Looks like a helipad location.
LNM shows runway ID's reversed. Same on world map
Windsock visible near cabin - direction ok
Start at 33 actually should be 15 - Initial start at Airport Location - Press Fly and goes to runway.
Start at 15 actually should be 33 - Initial start at Airport Location - Press Fly and goes to runway.

 

IDDWL
Prk 1 - Helipad but heli too far fwd.
Prk 2 - Near runway 26
No windsock seen
World Map and Little Navmap runways reversed

Select runway 8 World Map - starts at 8
Select runway 26 World Map - starts at 26 - Initial start at Airport Location - Press Fly and goes to runway.
Hawk flying around

 

ITMN
LNM shows Prk 3, Rwy 16/34
World Map shows P1,P2 & P3
Select Prk 1 - Located quite far from airstrip - Trinity Mtn Hill Climb - ok

Select Prk 2 - Located quite far from airstrip - Helipad at Mtn Climb Start - ok

Select Prk 3 - Near end of runway 16 - snow on load 

 

[P3D v4 compatible third party software.]

Just noticed that the Alabeo R66 Turbine for P3Dv3 & v4 is available.

I was able to get a free upgrade through my SimMarket account.

 

http://www.alabeo.com/index.php?accion=product&correl=97