astro744 Posted January 11, 2014 Share Posted January 11, 2014 Hi, It has been a couple of years since I got FTX AU SP4 and a heap of airports. I think I installed all the AU airports with FTX Central set to default. I would then run FTX Central and click on Australia and apply, run FSX and test the airport I had just installed. I would then run FTX Central and set to FSX Default and apply. I would then run FSX and load any flight and close. I only did this last step since I noticed the scenery files update when starting FSX after switching back to default. Anyway, I recently bought some NZ, EU & NA regions as well as a few more airports. I have only installed one of these new airports and that being KJAC but I installed this with FTX Central set to FSX Default and I read on your FAQ section of this forum that for North America airports, FTX Central should be set to North America. Is this correct and does this only apply to NA airports and not EU AU or NZ airports? If so then how do I go about uninstalling KJAC and re-installing it correctly? Note there are three exe setup files for KJAC and I assume I run files 2 & 3 after completing the initial setup file. Correct? astro744 Link to comment Share on other sites More sharing options...
Alex Goff Posted January 13, 2014 Share Posted January 13, 2014 The FTX Central setting for airports is not incredibly important, for most it doesn't matter at all. But if you want to play it safe, install with FTX Central set to the region the airport is in. And correct on running the remaining two executables for KJAC, those contain more of the very large photoreal area surrounding the airport. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.