kids1219x Posted December 2, 2012 Share Posted December 2, 2012 When I install FTX NZ South Island, I cannot install by the following message. --------------------------------------------------------------------------------- Installation Aborted Set up was not completed Successfully. Ectract:error writing to file FTXNZSI110.exe ---------------------------------------------------------------------------------- Is this a problem of a FTXNZSI110.exe file? Although the value of MD5 was checked, there was no problem. My systen as follows; Windoes 7 professional 64 bits SP1 FSX Acceleration pack installed Please give me the advice for solving this problem. Best regards Link to comment Share on other sites More sharing options...
kids1219x Posted December 3, 2012 Author Share Posted December 3, 2012 Dear Friend I solved this problem, please close this iSSUE. A cause is proved that it is the shortage of capacity of RAM Disk currently used for unwrapping. Best redards Link to comment Share on other sites More sharing options...
FlipS Posted October 25, 2013 Share Posted October 25, 2013 When I try to install FTX EU England, I have the same experience. How many RAM is needed? My pc has 8 GB. Link to comment Share on other sites More sharing options...
FlipS Posted October 26, 2013 Share Posted October 26, 2013 I solved this problem. I have FSX on the E:drive, downloads on the D:drive. The installer is unwrapped on the C:drive; there was too less room. After making room, installation succeeded. Link to comment Share on other sites More sharing options...
Skids Posted October 27, 2013 Share Posted October 27, 2013 When I try to install FTX EU England, I have the same experience. How many RAM is needed? My pc has 8 GB. Good Morning afternoon all, I have had a similar problem with ORBX England. I purchased the hard copy DVD of this scenery package and have issues installing it. The setup starts to run but about half way through it asks to insert disc2, I manage to eventually get it to continue by removing and inserting the dvd a number of times and then get asked for disk3. This is where it stops completely. The dvd has not been damaged this end as it is new. I also am told by a friend that he has the same problem with the New Zealand scenery DVD. I also tried his DVD on my machine with the same problem. I then made a Copy of the NZ DVD to a new blank DVD and tried that. This copy of the original worked perfectly. Seems that some of the DVD's released are faulty? Can anyone advise please? These scenery packages are completely legit and purchased versions in original boxes from flightsimstore.com Regards Paul Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.