Demious Posted August 12, 2015 Share Posted August 12, 2015 I loaded up a flight at 1S2, but when the flight was almost at 100%, P3D crashed without any error messages. I tested other airports in PNW and all are fine, except for 1S2. I reinstalled the airport, installed libs, ran Central and Vector, but no improvement. I took off from another aiport close by to check if I could get into the addon's area, but when I got close to 1S2, there were no buildings at the airport, just some black squares where the buildings should be. When changing the angle of the view slightly, I could make the buildings appear, but only for as long I kept my view within a small angle, moving too far made the buildings disappear again. Underneeth is shown the difference when moving the view angle up and down: What might be wrong and what can I do to fix it? Link to comment Share on other sites More sharing options...
Demious Posted August 23, 2015 Author Share Posted August 23, 2015 Some help would be very much appreciated. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.